Manual

Rev. 11/11
Page 2 of 4
SB
YJ: 11632.10
CJ: 11633.10
CJ/YJ ALL TERRAIN FLARE KIT
Step 6. Install the hardware as shown in the image. First place a washer on
the M5 bolts. Place one bolt through each hole in the are. Next
place a rubber spacer on the bolt on the back side of the are. Some
of the spacers are dierent in thickness. Follow the instructions in
the next steps to determine placement of each spacer.
Step 7. Installing the front ares. First you will install the side marker in the
are using two phillips head screws. Install a 7mm rubber spacer
on both marker light screws. Install one 7mm rubber spacer on the
front mounting screw. Install a 13mm spacer on the remaining
mounting screws. Mount the are on the body placing a M5 nut on
each bolt. Finally tighten the side marker screws. Do not over
tighten the marker light screws or mounting nuts.
Step 9. Install the front are extensions using the factory M5 bolts.
Step 8. Installing the rear ares. Install the rear fender ares using a 7mm
rubber spacer on each screw. Mount the are on the body placing
a M5 nut on each bolt. Finally tighten the nuts. Do not over
tighten the mounting nuts.