User Manual

Copyright © 2015 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [e-mail]
PERFORMANCE HOOD VENTS
Page 7/8
18. For JK models, replace hood insulation blanket.
If optional hole cutouts from steps 12-16 were made:
do not re-install christmas tree fasteners yet. Use a
marker to trace hole cutouts onto hood insulation
blanket. Use scissors or razor to cut corresponding
holes in hood insulation blanket.
16. Remove painters tape. Use a deburring tool
or hand le to remove any burrs or sharp edges
created in steps 10-16.
17. Use touch-up paint to cover any exposed metal
resulting from cutting and drilling. Allow paint to dry
before proceeding.
13. Remove hood template and painters tape.
14. OPTIONAL - Use painter’s tape to connect each
1” hole with a straight line of tape around outside
edges of each hole as shown in template.
15. OPTIONAL - Carefully use an angle grinder with a
metal cut off wheel or metal nibbler to cut top layer
of hood sheet metal along inside edge of painter’s
tape.
Always wear gloves, safety
glasses, ear protection, and dust
mask when cutting metal.
WARNING
!
Always wear gloves, safety
glasses, ear protection, and dust
mask when cutting metal.
WARNING
!