User Manual

Page 3 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
10 - Remove 5 inner fender
bolts (arrows). Note
location of bolts. Bolts
will be reused.
11- Following four images show
locations of key inner fender
bolts. Rear inner bolt may be
recessed under inner fender
liner. See arrow for bolt
location.
12 - Remove top fender
support bolt.
13 - Remove front inner bolt.
Bolt is located under inner
liner just behind front grill.
14 - Loosen inner door fender
bolts. Do not remove. Allow
enough clearance for
fender to slide out easily.
Notice: If door remains
installed bolts should be
removed to avoid damage
to vehicle if door is closed.
15 - Remove lower pinch weld
fender bolts. Note location
of bolts. Bolts will be reused
NOTICE: On some models
rock rails or side steps will
need to be removed before
bolts can be accessed.