User Manual

Page 2 of 3 REV.1 06/25/2012
High Intake Installation Instructions: (2007 - UP) Wrangler 2DR & 4DR Unlimited
P/N: 17756.07 - XHD Modular High Mount (Ram intake)
High mount installation:
5 - Install mounting bracket
the back of high mount
intake using (2) M6 hex
head bolts and washers.
secure bolts but do not
tighten at this time.
6 - mount bracket and intake
to windshield bracket
using T-40 torx bolts
removed in step (4).
Secure bolts but do not
tighten.
4 - Use a T-40 torx head socket
to remove top (2) windshield
bracket bolts. Do Not discard.
Bolts will be reused.
7 - Insert (4) M6 caps head
bolts and washers through
intake to snorkel main
body. Tighten bolts.
DO NOT OVER TIGHTEN.
Tighten enough to insure
tight t of gasket to snorkel
main body.
8 - Tighten mounting bracket
to windshield.
9 - Tighten mounting bracket
to high intake M6 bolts.
Turn on windshield wipers
to check for clearance.
Adjust as needed.
NOTE: vehicle must be
equiped with OE correct
16” wiper blades.