User Manual

Page 23 of 23 REV.1 06/25/2012

Omix-Ada Inc.

460 Horizon Dr. Suite 400

Suwanee, Georgia 30024

P/N: 17756.06 - Fender Template (1:1 scale)

CUT OUT LOCATION

GUIDE CUT OUT

FOLD ALONG DOTTED LINEFOLD ALONG DOTTED LINE

Cut out template using scissors or X-ATCO blade. The template

is a (1:1) scale guide for cutting top of passenger side (LH) fender.

NOTICE: Make sure guide cut outs align correctly with the top

of fender. If guide cut outs DO NOT MATCH top of fender

please contact Rugged Ridge for correct template. Template

ratio can change size during the printing process. Every eort

is made to insure correct sizing of template for installation but

we do request that it is double checked prior to marking and

cutting of vehicle fender. Failure to follow instructions may

result in a poor tting component or damage to fender.

(770) - 614-6101 (Attn: Tech Department)

Snorkel system has been designed to reduce possible

hydro locking caused by water entering intake system. The

system is designed to provide dry, clean air to the engine and

should not be used to exceed manufactures recommended

fording depth. Proper o road driving technics should be used

when fording any type of legal water crossing. It is the owners

responsibility to judge conditions prior to placing vehicle in

a situation where water intake is possible. The system should

be used as a safeguard and not a full 100% sealed intake

sytem. Rugged Ridge / Omix-Ada Inc. is not responsible for

damages caused by improper installation an or use of snorkel

system. System should be cleaned and ushed annually. Drain

should be inspected and water expelled on a regular basis.

Manufactures warranty covers only products supplied by

Rugged Ridge / Omix - Ada Inc.