User Manual

Page 21 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
118 - Insert plastic spacers
between snorkel body
and intake. Insert M6
x 55mm caps head bolts
through logo plate.
Start threads but do
tighten.
119 - Press top of intake
down onto snorkel
body.
120 - Using (4) M6 short caps
head bolts and (4) M6
at washers secure intake
to snorkel body.
121 - With intake secure
pull outer edge of
“U” gasket away from
intake until gasket
rest at against side
of intake.
122 - Tighten all (6) caps
head bolts.
Do Not Over Tighten.
A rm seal is all that
is required.
123 - Reinstall antenna mast.