User Manual

Page 19 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
107 - Slide fender up & over
fender support bracket
(noted in step (12).
Inspect area around
snorkel body. Fender
should t tight to seal
but should not be forced
to align with fender
mounting holes. If
fender opening needs
to be trimmed for better
t refer to steps (30)
through (36).
106 - Reinstall fender.
Notice: The help of a
second person is
recommended.
Before installing fender
to vehicle make sure
antenna cable is attached
to fender antenna mount.
108 - Align inner door fender
tabs with door bolts.
Slide tabs under bolts
and secure but do not
tighten at this time.
109 - Align lower fender
holes with pinch
weld mounting holes.
Reuse bolts removed
in step (15). Secure
bolts but do not
tighten at this time.
110 - Secure top of fender to
inner fender frame.
Battery tray support
will need to be lifted
to allow fender to slide
under support.
111 - Reinstall all remaining
bolts removed in steps
(8) through (13).
Secure all bolts but
do not tighten at this
time.