User Manual

Page 16 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
89 - Slide 3” clamp onto
aluminum air tube.
Apply sealant evenly
around outside of tube
(arrow). Sealant should
be evenly spread 1”
back from end.
88 - Secure 3” clamp around
main body lower outlet.
Smooth and clean extra
sealant from snorkel
body.
90 - Slip main snorkel body
and coupling over air
tube as shown.
91 - Slide 3” clamp over
coupling end. Inspect
t and alignment of
main snorkel body to
aluminum air tube.
Slight misalignment is
OK . Body lifts over 1”
are not recommended.
92 - Snorkel main body
should rest in place
as shown. Snorkel body
should be tted tight
to inner frame. Make sure
antenna cable is not
hidden behind snorkel
body.
93 - Tighten 3” clamp. Smooth
and clean extra sealant
from parts.