User Manual

Page 12 of 23 REV.1 06/25/2012
Snorkel Installation Instructions: 2007-2011 Wrangler 2DR & 4DR Unlimited
P/N: 17756.06 - Low Mount XHD Modular Snorkel System
65 - Apply extra sealant to top
of grommets.
64 - Remove top rubber
grommet from air box
mounting plate (arrow).
Apply sealant to the
inside of two lower rubber
grommets as shown. Make
sure sealant completely
lls the two holes.
66 - Apply sealant to
coresponding holes on
the underside of inner
fender mounting plate.
67 - Place new air box
down onto elbow
and align mounting
holes with rubber
grommets.
68 - Press air box fully onto
elbow and slide 3” clamp
into place. Clamp should
be pushed all the way to
the top towards lower
air box (arrow).
69 - Tighten 3” clamp to air box.
Make sure clamp is slid
over inlet of lower air box
and just under the bottom
of box. Clean away extra
sealant.