Owners manual

P
age 5 of 6
Door Seal Adjustment Procedures (Rear Doors)
Pic. 28 Pic. 29 Pic. 30
Pic. 25 Pic. 26
Pic. 27
19. Open half door and grab the excess weather-stripping closest to the Windshield frame. Place the weather
stripping behind the post of the soft upper frame (Pic. 25). Adjust as needed to ll gap between windshield
frame and upper door .
20. Trim rear weather-stripping so that it slightly overlaps the weather-stripping of the half door (Pic. 26 -27).
21. Rear upper door frames are installed using the same procedures and techniques discribed in steps (2-19).
22. Apply Velcro to lower doors as described in step (2). Velcro should be positioned 1/8” from the top of lower
1/2 door. Press Velcro rmly into place to ensure good adhesion (Pic. 28).
23. Position rear upper frames onto lower doors. Top corners should have a 1/8” gap between the top of
upper door and soft top (Pic. 29). Adjustment of rear upper doors will be the same as fronts. See steps (4-12)
for proper alignment procedures.
24. After upper doors have been positioned correctly with 1/8” gaps check for visible light from inside vehicle.
If light is visible rear upper doors should be adjusted in the same manner as the fronts (Pic.30).
See steps (14-19) for proper alignment procedures.
25. When bending frames small adjustment should be made. (DO NOT OVER BEND) Continue to make small
adjustments until a tight seal has been made around door opening.