User Manual

Copyright © 2015 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [e-mail]
Rev - 3/2015
3. Place rocker guards into position. DO NOT remove
red liner at this time. Visually inspect t of part to conrm
mounting holes are aligned and install bolts, washers,
and lock nuts loosely. Rocker guard will hang away from
vehicle.
4. Peel red liner from back of tape working from outer
edges inward. Make sure that all tape covering is pulled
back at the same time. This will insure that all the protecitve
covering is removed during installation.
NOTE: The help of a second person is recommended for
this step.
5. Attach rocker guard to the vehicle keeping part aligned
to the vehicle surface. Apply pressure to ensure a strong
bond. Tighten bolts and nuts.
NOTE: The help of a second person is recommended for
this step.
Repeat #1-5 for opposite side of vehicle
11651.11
11651.12
Page 2/2
JK Rocker Guards