User Guide

Copyright © 2016 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [e-mail]
JK Off-Road Jack Mount Bracket
Page 3/4
4. If installing on a vehicle with a Rugged Ridge tire
carrier (A), secure Jack Mount to lower mounting
plate’s top two holes using M10 hardware. If using
with Hard Top, add M10 spacer between Mounting
Plate and Jack Mount.
Rotate Upper Mounting Plate into its horizontal position
behind Jack Mount and attach with M8 hardware.
For use with Hard Top, add M8 spacer between Upper
Mounting Plate and Jack Mount.
If no Rugged Ridge tire carrier is present, rotate Upper
Mounting Plate into horizontal position and tighten
upper left tailgate hinge bolt to hold in place. If using
with Hard Top, add M8 spacer between Mounting
Plate and Jack Mount.
Install nal M10 bolts into bottom holes in mounting
bracket as shown. If using with Hard Top, add M10
spacer between Mounting Plate and Jack Mount.
A
B
8. Tighten all hardware.
9. To install Off Road Jack, use bottom knob to clamp
base of jack into position ensuring rear of base is under
tab in mounting bracket. Close top swing arm making
sure rubber pads grip jack’s vertical beam.