User Manual

, Inc.

460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix-ada.com

Spare Tire Spacer

1. Body Mount (1)

2. Wheel Mount (1)

3. Flat Washer (5)

4. Lock Washer (6)

5. Locking Hex Nut (2)

6. M12 x 1.25 x 35 Hex Bolt (3)

7. M12 x 1 x 30 Hex Bolt (2)

8. M12 Hex Nuts (3)

9. 1/2-20 Hex Nuts (3)

10. M12 x 1.25 Lug Nuts (3)

1. Remove spare tire. Install Body Mount using Flat

Washers and Lock Washers. Depending on factory

stud sizes use either M12 Hex Nuts, or 1/2” Hex Nuts

to attach Body Mount to vehicle.

NOTE: M12 Nuts will install on on 1/2 factory stud, but

will NOT be secure. 1/2” Nuts will NOT install on M12

factory stud.

Page 1/2

11585.02

Components:

OMIX-ADA

TECHNICAL SUPPORT

PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: techsupport@omix-ada.com

FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com

Read all instructions thoroughly before installation.

Rev 09/2013

1 5

PAGE 1
Page 1/2 11585.02 460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix-ada.com Spare Tire Spacer Components: 1. 2. 3. 4. 5. Body Mount (1) Wheel Mount (1) Flat Washer (5) Lock Washer (6) Locking Hex Nut (2) 6. M12 x 1.25 x 35 Hex Bolt 7. M12 x 1 x 30 Hex Bolt 8. M12 Hex Nuts 9. 1/2-20 Hex Nuts 10. M12 x 1.25 Lug Nuts 9 (3) (2) (3) (3) (3) 10 8 7 2 3 4 1 5 6 1. Remove spare tire.
PAGE 2
Page 2/2 11585.02 460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix-ada.com Spare Tire Spacer 2. Attach Wheel Mount to Body Mount using M12 x 30 Hex Bolts, Flat Washers, and M12 Lock Nuts. Mount is slotted to allow side-to-side adjustment. Set side-to-side position and tighten Lock Nuts. 3. Use diagram below to determine proper bolt pattern for your vehicle. Install M12 x 35 Hex Bolts and Lock Washers into your bolt pattern. 4.