User Manual

Copyright © 2013 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [e-mail]
Page 2/2
Rugged Ridge
®
X-Clamp
OMIX-ADA
®
TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [e-mail]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Patent Pending
1.DisassembletheX-ClampFrontandX-ClampBackbylooseningthejamnutsthenremovingthe4bolts
and 8 jam nuts.
2.DeterminethecorrectorientationtomounttheX-ClampbyholdingtheX-ClampFrontandX-Clamp
Backtothetube.RotatetheX-Clamppieces90°tomakesureyouhavethecorrectorientation.
6. Attach mounting tab to X-Clamp Back. Tighten to 8 ft-lbs.
 ApplyredLoctite(R)orequivalentthreadsealerbefore
tighteningthreadsofatheadscrew.
7.ApplylogotorecessinX-ClampFront.
3.Selectappropriateboltlengthforyourtubediameter.2.5”and3”
diameter tubes require jam nuts. Note: to prevent jam nut
interference with the high point of tube, keep jam nuts separate on
bolt shaft during install.
4.AttachX-Clamptotubebygraduallytighteningallboltsevenlyin
an “X” pattern. Tighten to 3 ft-lbs. Do not exceed 3 ft-lbs.
5.Tightenjamnutstoasnugt.Donotovertighten.Makesurebolts
are tightened before tightening jam nuts.
2”
2.5”
3”
11030.01
11030.10
Keep jam nuts close
to X-Clamp Front and
X-Clamp Back
PATENT PENDING
  Inspectandretourquefastenersafterrst50
milesandfrequentlythereafter,particularlyafteruseoff-road.
DO NOT USE & REPLACE IF X-CLAMP OR FASTENERS BECOME
DAMAGED.
WARNING
!
NOTICE