User manual

Page 11
2.2.1 List of Connectors
The board has a number of connectors that allow you to configure your system to
suit your application.
The table below shows the function of the board's connectors:
2.2.2 Setting Jumpers
You configure your card to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch. It consists of two metal pins and a
small metal clip (often protected by a plastic cover) that slides over the pins to
connect them. To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2 or 2 and 3.