User Manual

5
2. Place your finger onto the sensor until you hear a beep.
3. Repeat Step 2 five more times. The sensor will turn green when your fingerprint
is accepted.
If your fingerprint is not accepted, the sensor will beep and turn red. Continue to
repeat the steps until complete.
Note: Make sure the key lock is in the vertical position, so the
cabinet door lock engages properly.
Deleting Fingerprints
Deleting fingerprints will delete all fingerprints stored in the memory.
Use the config. key to press and hold the config. button for about four seconds, until
you hear four beeps, and then release.
Auto and Manual Mode Selection
There are two modes for accessing the inside of the EDC-FP90L. In manual mode, your
fingerprint unlocks and locks the dry cabinet. In automatic mode, your finger unlocks
the cabinet, but the unit automatically locks in about four seconds. The EDC-FP90L’s
default setting is auto mode.
Warning! Switching modes will delete all stored fingerprints.
To change the mode, use the config. key to press and hold the config. button until you
hear a series of four beeps and then two beeps.
Low Battery Warning
If the fingerprint lock has low battery power, it will beep six times. Replace all the
AAA batteries immediately. If the batteries die, use the included USB adapter and
power adapter with the lock’s USB port, or use the included keys to manually unlock
the door. See Opening the Cabinet for the First Time above.
Important: Keep the keys and USB adapter in a safe place so you can access the contents
of the dry cabinet if the batteries fail.
Locked Unlocked