Assembly Instructions

Snow Roof Rake Assembly Instructions
Please read instructions completely before assembling
NOTE: Do not fully tighten nuts and bolts until the entire rake is assembled
1. Determine which end of the angled tube contains the tube connect nut. Align the center hole in blade
with the tube nut inside the angled tube. Insert bolt through lock washer, large washer, blade and into
the tube nut. Loosely hand tighten.
2. Attach Angle Brackets through bent tube using 1 ¾” long Phillips Head Screw and lock nut.
3. Attach Angle Brackets to each end of roof rake blade using ½” Phillips Head Screw and lock nut.
4. Tighten all bolts securely
5. Slide 1” diameter tubing into angled tube while compressing spring buttons. Align the holes in angled
tube with spring buttons to allow buttons to pop out.
6. Slide 1 1/8” diameter tube over 1” tube and compress spring buttons. Align the holes in 1” tube with
spring buttons to allow buttons to pop out.
7. Slide the remaining 1” tube into 1 1/8” tube using same procedure.
8. Slide comfort grip over end of 1” tube
CAUTION: DO NOT USE NEAR ELECTRICAL WIRES
Rugg Manufacturing Corp.
Leominster, MA.
www.rugg.com
[e-mail]