Manual

The RECEIVER securely locks the barrel into a low, direct line with the hands to minimize felt recoil and maximize pointability.
8
NOMENCLATURE - RUGER TRAP MODEL SHOTGUN
The BUTTSTOCK is held on the gun by a long through-bolt, which is accessible only after the recoil pad base plate on the end of the buttstock is removed. It is adjustable for length of pull from 13 1/2” - 15 1/2”.
The TOP LEVER and its massive pivot are one integral component directly engaged with the locking bolt on both opening and closing motions.
The PISTOL GRIP is finely cut- checkered and is of special target style and contour.
The MONOBLOC securely locks the barrel/rib assembly into the receiver.
The TRIGGER is set at the factory at a 3 - 4lb. trigger pull. This can be adjusted to some degree. (See pp. 29 - 31)
The TRIGGER GUARD protects the trigger from inadvertent contacts which could cause the gun to discharge.
The COMB of the stock is
adjustable for height, cast-off, and cast-on.
The BUTTPAD is screw- adjustable for “cant”.
The VENT RIB can be adjusted for height and is free to float as the barrel expands.
The special low mounted “controlled pattern” trap BARREL is hammer forged stainless steel, back-bored, with screw-in chokes. (Not seen in this view)
The finely checkered beavertail FOREND is designed to afford a comfortable grip for the pointing hand.
Figure 1.