Manual

31
During initial firing on a suitable clay target firing range after any trigger
adjustment, be extra observant to be sure the shotgun is operating correctly. If
you have any questions as to the gun’s safe operating condition, cease firing
immediately, unload the shotgun, and contact the Ruger Newport Product
Service Department.
Reassemble buttstock to the receiver, noting caution on page 23.
REGARDLESS OF THE TRIGGER PULL WEIGHT, KEEP YOUR FINGER OFF
THE TRIGGER, COMPLETELY OUTSIDE THE TRIGGER GUARD, UNLESS YOU
ARE IMMEDIATELY FIRING AT A SELECTED CLAY TARGET!
MAINTENANCE OF
STAINLESS STEEL COMPONENTS
Firearms and components made of stainless steel are relatively more resistant to
corrosion than those of blued steel. However, in the interest of proper operation
and long life of a stainless steel firearm, inspect it frequently and clean, lubricate
and apply an appropriate rust preventative.
Sometimes discoloration occurs from perspiration or from contact with some
types of gun cases. Rusting may occur as a result of the firearm being exposed to
moisture, salt air or chemicals.
Minor discoloration can usually be removed by rubbing the stainless steel area
with an abrasive ink eraser, crocus cloth, or a “metal polishing” compound. When
using any of these abrasives, proceed with care and use light pressure to achieve
a blending of “color” with those areas that are not discolored.
External surfaces most subject to rusting from handling, or from exposure to the
elements should be cleaned and wiped dry after use or after exposure to adverse
conditions. If the shotgun is to be stored, coat it with a light film of oil or
preservative. Where the shotgun is in continuing use, and the presence of oil or
grease would be objectionable, then the external surfaces can be coated (after
cleaning and drying) with a paste wax formulated for use on metals. Apply the
wax sparingly, allow time for it to dry hard, then buff lightly with a soft cloth.
When applying the wax, take care that it does not get into the mechanism or on
the functioning parts or in the bore.