Manual

C. To adjust the comb for CAST OFF or CAST ON, loosen the two Allen screws
on the right side of the comb and remove the comb from the buttstock.
Loosen the screw located inside the top
of each of the posts. If cast off is
desired, move each of the posts to the right
approximately the same amount
and retighten the screws. To get cast on
, move the posts to the left. Re-install
the comb and check your sight picture. Readjust if necessary until all
adjustments put the pattern at the preferred location for the individual
shooter. Then tighten all adjustment screws secur
ely.
To Raise or Lower the Height of the Buttstock
B. To adjust the COMB HEIGHT, loosen the two Allen clamp screws on the
right side of comb of the stock. Raise or lower the comb to the desired height
and securely tighten the clamp screws.
Loosen Screws
1
2
3
Retighten Clamp Screws
Loosen Screws
1
2
3
Retighten Screws
Loosen Screws
3
Retighten Screws
1
2
For Cast-Of
f,
Move Screws To Right
For Cast-On
,
Move Screws To Left
28