Manual

12
4. Swing the muzzle end of the barrel upward, pivoting the rear end of the
monobloc downward to seat in the receiver as shown in Figure 4. The barrel
assembly is seated and locked into the receiver when the top lever snaps to its
centered position.
5. Push the rear end of the forend iron back over the ends of the ejector as
shown in Figure 5. Then carefully swing the front end of the forearm upward
until the forend latch lever catches the forend latch hook on the underside of
the lower barrel, and the forend assembly snaps into its locked position flush
with the stock.
Figure 4
Figure 5