Manual
10
TO UNCOCK (DECOCK) THE REVOLVER
If your revolver is cocked, and you wish to let the hammer down to its forward
position (against the frame), proceed as follows: USE EXTREME CARE WHEN
ATTEMPTING TO DECOCK THE REVOLVER, AS THE THUMB SLIPPING
DURING THIS PROCESS CAN RESULT IN AN ACCIDENTAL DISCHARGE IF
THE TRIGGER IS HELD TO THE REAR.
1. Make certain that the revolver is pointed in a safe direction (See Rule 2, Page
27).
2. Make certain both hands are dry and not impeded in any way – gloves,
bandages, cold, etc.
3. Grasp the revolver (if right handed) so that the thumb and forefinger of your
left hand are firmly holding the frame, forward of the trigger guard. Thus,
your left hand is in full control of the revolver (See Figure 4A, Page 11).
4. Place your right thumb firmly on the hammer spur and, with your thumb
securely in control of the hammer, squeeze the trigger only enough to permit
the hammer to ‘break free’ of the trigger. At that instant, IMMEDIATELY
RELEASE THE TRIGGER and then slowly permit the hammer, STILL
SECURE UNDER YOUR THUMB, to move fully forward to its resting position
against the frame. NOTE: It is imperative that finger pressure be removed
from the trigger just as soon as it is free of the hammer. Then, properly, the
trigger and hammer will move towards their fully forward rest positions
together (See Figure 4B, Page 11).
WARNING–FIRING
When firing the Super Redhawk revolver,
be sure all persons are a safe distance to
the rear of the shooter. When fired, all
revolvers discharge hot gas and particles
of lead, powder grains, or lubricant
through the clearance gap between the
cylinder and the rear of the barrel at high
speed. This can injure a person who is
standing too close to the revolver.
When firing the Super Redhawk revolver
(or any revolver), always be certain that
nothing – including your hands – is in
the path of the hot gas and particles
which are discharged from the front and
sides of the cylinder.
When shooting, adequate eye protection
is essential. Shooters and bystanders
must wear shooting glasses. Hearing
protection must also be worn. Exposure
to shooting noise can damage hearing.
HOT GASES EXIT
BARREL/CYLINDER GAP










