Manual

SIGHT ADJUSTMENT
RUGER
®
SR-SERIES pistols are equipped with a rear sight which is
adjustable for both windage and elevation.
To adjust for elevation
, rotate the screw
in the rear sight clockwise or counter-
clockwise to lower or raise the sight,
respectively. (See Rear Sight Elevation
Adjustment photo.) Note that lowering
the rear sight will lower the point of
impact, and raising the rear sight will
raise the point of impact.
To adjust for windage
, after the rear-
sight lock screw has been loosened
using a 5/64” Allen wrench, the rear
sight can be drifted laterally in its
dovetail on the top of the slide by
tapping it with a wooden- or plastic-
headed hammer or similar implement.
Move the rear sight in the direction you
want the shot to move on the target.
After the rear sight is adjusted, tighten
the rear-sight lock screw. Both front and
rear sights are provided with white-dot
inserts for rapid target acquisition and
easy alignment of the sights to obtain a
correct sight picture.
33
REAR SIGHT
ELEVATION ADJUSTMENT
WARNING—BEFORE SHIPPING ANY FIREARM,
BE ABSOLUTELY CERTAIN THAT IT AND ITS
MAGAZINE ARE UNLOADED. DO NOT SHIP
CARTRIDGES WITH A FIREARM.
!
SERVICE AND PARTS POLICY
If you have any questions with regard to the performance of your RUGER
®
SR-SERIES pistol, please write or call (928-778-6555) our Product Service
Department in Prescott, Arizona, fully describing all circumstances and
conditions involved. If you should return your pistol to the factory for repair, or
order parts for it, please comply with the following suggestions for prompt
service:
SHIPPING FIREARMS FOR REPAIR:
RUGER
®
SR-SERIES of pistols returned to the factory for services or repair
should be sent to: Sturm, Ruger & Company, Inc., Product Service Department,
200 Ruger Road, Prescott, AZ 86301-6181. Telephone [phone].