Manual

26
TO REASSEMBLE
1. Be certain the chamber and magazine are empty. Always keep the pistol
pointed in a safe direction.
2. With the slide held upside down, replace the barrel and push it rearward into
its locked position. The rear end of camblock seats against barrel lug.
3. Place the recoil spring assembly into position. Make sure that the plastic end
of the recoil spring goes into the slide.
4. Be certain that ejector is pulled down and locked in its lower (forward)
position. Push the trigger into its fully forward position.
5. Replace the slide onto frame. Pull the slide fully back and lock it into position
by pushing upward on the slide stop.
6. Now push the takedown pin all the way through the frame to the right.
7. Allow the slide to move fully forward by releasing the slide stop.
8. Replace the empty magazine in frame through butt of pistol. This action
returns the ejector to its working position. This pistol will not function
normally unless the ejector is in its upward (rearward) position.
REVERSING THE BACKSTRAP
To accommodate personal grip preferences and styles, the SR9
TM
is equipped
with a unique reversible backstrap. One side provides an arched surface; the
reverse side is flat.
1. To reverse the backstrap,
begin by removing the
backstrap retaining pin using
a correctly sized Allen
wrench or large paper clip
(shown here). Simply push
the pin out and set it aside.
(See Figure 17.)
FIGURE 17
Push Pin
Out