Manual

32
REAR SIGHT INSTRUCTIONS:
1. Remove magazine and ensure the chamber is empty.
2. Unscrew clamp assembly and place sight so as to allow the clamp screw to rest in
the rear most rail cross-slot of the flat top receiver. Sight should be orientated to
fold to the rear (see Fig. 32).
3. Apply one drop of thread locking compound on exposed threads and replace clamp
and tighten while pushing sight forward against cross slot (see Fig. 33).
OPERATION
1. To raise the sight, grasp and pull up until sight locks in upright position.
2. To fold, depress the button located on the left side of the base and fold.
ZEROING PROCEDURES
1. Fire a group and measure from the point of aim to the point of impact.
2. Adjust the rear sight for windage only.
Adjustments can be made with a coin
or small diameter blunt tool (see Fig.
34).
3. Elevation adjustment is made off of the
front sight post.
4. Sight apertures are on the same plane
and either can be used without a
change of impact.
5. Confirm zero with a group of aimed shots and adjust as necessary.
ADJUSTMENT
1. To move the bullet impact right – turn adjustment wheel to the right / clockwise.
2. To move the bullet impact left – turn adjustment wheel to the left / counter
clockwise.
Value for one click of adjustment 100M 200M 300M
.33MOA 1/3” 2/3” 1”
Figure 32
Figure 33
Figure 34
Depress button
to fold sight
back.