Manual

REASSEMBLY
Again Be Sure Rifle and Magazines are Completely Unloaded!
1. Reassemble the charging handle and bolt carier into the upper receiver:
a. Turn the upper receiver upside down so that the top of the rifle is pointing
toward the ground. Install the charging handle with the pick up lug
pointing toward you. Slip the charging handle guides into the cut out in
the upper receiver and leave the charging handle sticking out of the rear of
the upper receiver. (See Figure 14, pg. 24.)
b. Turn the bolt carrier upside down and, making sure the bolt is fully
forward, lay the bolt carrier on the charging handle and push both the bolt
carrier and the charging handle forward until the charging handle lock
engages the upper receiver. Care should be taken not to turn the upper
receiver so that the bolt carrier can slide out the back of the upper receiver
while the charging handle is unlocked. The bolt carrier will not fall out of
the upper receiver as long as the charging handle is locked on the upper
receiver. (See Figures 13, 12, & 11, pg. 24.)
2. Assemble the upper receiver to the lower receiver:
a. Make sure the hammer is cocked
(see Figure 23), place the selector on
“SAFE,” and make sure both the
take down pin and pivot pin are
pushed completely to the right side
of the lower receiver. Make sure the
bolt carrier is all the way forward in
the upper receiver. Put the upper
receiver onto the lower receiver and
slide the upper receiver all the way
rearward against the threaded
section of the butt stock. Push the
pivot pin into the receiver until the detent locks in the hole in the pivot
pin. Push the take down pin into the receiver until the detent locks in the
hole in the take down pin. (See Figures 10 & 9, pg. 24.)
3. Install the regulator:
a. Drop the piston into the piston bore in the
front of the gas block. Place the regulator
detent on the front of the gas block and
insert the regulator through the detent
and then the piston bore. Rotate the
regulator until its flat side is aligned with
the gas block hook. Push the regulator
into the gas block until the regulator rim
is seated against the regulator detent
(ensuring that the regulator detent arm
clears the grooves on the regulator).
Rotate the regulator so its rim engages the
gas block hook (see Figure 24).
26
Figure 23
Hammer is Cocked
Figure 24