Manual

21
MAGAZINE INSPECTION AND CARE
Check the magazine frequently. The rotor must move freely and have adequate
tension so that each cartridge is quickly raised to the feeding position. At the
time of manufacture, proper rotor tension is set by rotating the magazine cap
nut until the rotor
stops turning. Then the nut is turned an additional 1 1/4
turns beyond the ‘stop’ position.
To test the rotor tension, load one cartridge into the magazine and then firmly
press against the side of the cartridge case. Remove your finger quickly. The
cartridge should instantly and fully move in to the feeding position. If it does
not, the magazine should be cleaned. If cleaning does not restore proper rotor
tension, do not use the magazine. (NOTE: After testing, remove the test
cartridge.)
When cleaning is necessary, use a solvent that will not rust the metal
components or adversely affect the plastic magazine box. After the magazine has
been soaked in solvent to loosen foreign matter, be certain to shake it vigorously
(with the loading opening away from you) to remove solvent or residue from
within the magazine.
STOCK ADJUSTMENT
The SR-22
TM
RIFLE comes with a 6-position adjustable stock. There are
locking holes on the underside of the extension tube and there is a spring loaded
pin inside the butt stock. To adjust the stock, squeeze the rear part of the lever
on the underside of the stock against the stock and slide the entire stock
assembly in toward the lower receiver, or away from the lower receiver. Release
the lever and move the stock slightly in or out until the pin snaps into one of the
holes on the extension tube. Try the fit, and if necessary, readjust the stock. (See
Figure 5, below.)
Figure 5