Manual

21
WARNING - UNLOADING
REMOVING MAGAZINE
DOES NOT UNLOAD CHAMBER
Removing magazine does not unload pistol! To
unload, first
remove magazine, then pull slide to
rear, eject chambered cartridge, and visually inspect
chamber to be sure it is empty. Always point the
pistol in a safe direction when loading or unloading.
3. Place the safety lever into the down or “fire” position.
4. With the muzzle of the pistol pointing in a safe direction, and fingers outside
of the trigger guard, hold the pistol firmly and grasp the slide. Retract the
slide to its rearmost position briskly to extract and eject any chambered
cartridge. Always double check visually that the chamber, breech-face, and
the interior of the frame are clear of any live rounds. When the slide is fully
retracted, push upward on the slide stop, then allow the slide to move
forward until it comes to rest with the rear projection of the slide stop resting
in the notch on the lower left side of the slide.
5. To close the slide, again check to be sure the chamber is empty. Pull the slide
to its rearmost postion and release it. The slide will snap forward. Keep
fingers out of ejection port on top of slide!
6. If the magazine contains cartridges, they can be removed by sliding each
cartridge forward and out of magazine, one at a time, until the magazine is
empty.
7. Push empty (unloaded) magazine into frame until magazine catch locks it in
place.
!