Manual

NOTE: If you cannot supply sufficient force to the plunger using the mainspring
assembly as a “tool”, then use a screwdriver of appropriate size and insert
through hole in frame. It may be necessary to slightly depress the trigger while
removing the trigger guard assembly.
7. Cradle the revolver frame in your left hand and with the thumb of your right
hand press cylinder latch button, swing out cylinder assembly and remove it
forward from the frame.
8. Further disassembly is not essential for normal cleaning purposes. Any further
disassembly should only be undertaken by factory service personnel.
REASSEMBLY
AGAIN, BE CERTAIN REVOLVER IS UNLOADED!
Before starting reassembly, be certain that all components and the inside of the
frame are thoroughly clean. In particular the tongue on the front of the trigger
guard and its mating recess in the frame must be completely clean.
1. Replace cylinder and crane assembly in frame and close cylinder.
2. Hook front of trigger guard into recess in
frame (See Figure 7). Align pawl in its recess
in the frame and be sure transfer bar is in
correct position in frame then allow latch to
re-engage. If solid resistance is felt when
swinging trigger guard into frame, or if
trigger guard will not lock into position re-
check position of pawl and transfer bar (See
Figure 9).
TRANSFER
BAR
PAWL
6. Use mainspring assembly to depress trigger guard lock plunger located inside
frame at rear of trigger guard. Simultaneously pull down and remove trigger
guard assembly (See Figure 7 & 8).
20
Figure 7 Figure 8
Figure 9