Manual

NOTE: When ejecting fired cartridge cases, position the revolver at a
high angle so the cases will come fully out of the chambers and not slip
under the ejector. This high angle positioning is not necessary when
ejecting unfired cartridges.
18
SPECIAL INSTRUCTIONS FOR 9MM CLIPS
9mm revolvers require special clips to extract cartridges using the ejector rod
because this cartridge has no rim for the ejector to act against. Individual
cartridges may be fired without the clip, but will then require that each cartridge
or fired case be individually removed to unload the revolver.
TO LOAD CLIP:
Hold clip on outside diameter in one hand. With thumb and forefinger of
opposite hand, press cartridge’s extractor groove into clip until it snaps into
place. Continue until clip is fully loaded. Load cartridges, along with the clip,
into the cylinder.
3
2
4
1
CORRECT UNLOADING SEQUENCE