Manual

12
AMMUNITION (CARTRIDGES) NOTICE
WE SPECIFICALLY DISCLAIM RESPONSIBILITY FOR
ANY DAMAGE OR INJURY WHATSOEVER OCCURRING IN
CONNECTION WITH, OR AS THE RESULT OF, THE USE IN
THE SP101 REVOLVER OF FAULTY, OR NON-STANDARD, OR
“RE-MANUFACTURED”, OR HAND LOADED (RELOADED)
AMMUNITION, OR OF CARTRIDGES OTHER THAN THOSE
FOR WHICH THE FIREARM WAS ORIGINALLY CHAMBERED.
OPERATION OF
“DOUBLE-ACTION ONLY “ REVOLVERS
(This section applied only to “Double-Action Only” revolvers, identified by their
lack of a hammer spur)
The model you have selected is equipped with a special trigger mechanism that
permits only “double-action” firing. The hammer cannot be manually cocked,
since there is no full cock notch or hammer spur. The revolver can only be fired
by a relatively long (“double-action”) pull of the trigger which draws the hammer
rearward and then releases it to fire every shot.
It is important to note that the mechanism of the gun will not permit another
shot to be fired unless the trigger is first fully released and then pulled again.
The revolver has an internal transfer bar that will not allow the hammer to
contact the firing pin and fire the gun until the operator completely pulls the
trigger.
WARNING –DOUBLE-ACTION ONLY
Do not attempt to manually cock
the hammer! Since there is no full-
cock notch, the hammer will fall
forward when released, and if finger
pressure is applied to the trigger,
the revolver can fire. The automatic
safeties that prevent firing if the
hammer falls are deactivated if the
trigger is pulled. Do not touch the
trigger unless you intend to shoot
the revolver!
DO NOT COCK HAMMER