Manual

27
Because it is a serial numbered part, the frame of the RUGER
®
REDHAWK revolver is defined as a ‘firearm’ by Federal Law and is not
offered for sale as a component part.
Parts designated by an asterisk (*) must be factory fitted. These parts are
fitted on an exchange basis only. We will not return the replaced parts. We
will not return any part that is broken, malfunctioning, badly worn or has
been modified. See “Warning – Parts Purchasers” below.
NOTE: The Hammer Pivot Assembly (Part No. H01600 or KH01600) tab fits
into a mortise on the right side of the frame of most of the Redhawk
revolvers. However, during a change in production processing of frames in
1983, several thousand frames were made with the mortise on the left side of
the frame. A Redhawk revolver having the mortise on the left side of the
frame is in all other respects the same as the version which has the mortise
in the right side.
CAUTION: A gun containing modified, broken,
malfunctioning, or badly worn parts should not be fired.