Manual

18
6. Pull trigger guard latch to the rear (using mainspring lever) and
simultaneously pull trigger guard assembly, intact, out from bottom of
frame (See Figure 8).
7. Open cylinder and pull cylinder and crane assembly out of frame to the
front.
8. Further disassembly is not essential for normal cleaning purposes. Any
further disassembly should only be undertaken by factory service
personnel.
SPECIAL DISASSEMBLY INSTRUCTIONS
REVOLVERS NUMBERED BELOW 500-09367
The information below applies only to those revolvers in which the Hammer
Link (KH06900) is assembled to the hammer with the link hook pointing
downward, as illustrated in Figure 10 below.
If your revolver has a hammer link with the hook-opening pointing
downwar
d, follow the Disassembly instructions only through the first
sentence of numbered paragraph 4 on page 17 At that stage of disassembly
(with the hammer forward) proceed as follows:
1. Unlatch the hook of the hammer link from the top end of the mainspring
lever (See Figure 9 a., below).
2. With the trigger pulled, remove the hammer pivot assembly and hammer
(See Figure 10). At this stage of disassembly, return to the Disassembly
instructions on page 13 and pick up with numbered paragraph 5.
b.
a.
Figure 9
Figure 10
Figure 7 Figure 8