Manual

14
TO UNCOCK (DECOCK) THE REVOLVER
If your revolver is cocked, and you wish to let the hammer down to its
forward position (against the frame), proceed as follows: USE EXTREME
CARE WHEN ATTEMPTING TO DECOCK THE REVOLVER, AS THE THUMB
SLIPPING DURING THIS PROCESS CAN RESULT IN AN ACCIDENTAL
DISCHARGE IF THE TRIGGER IS HELD TO THE REAR.
1. Make certain that the revolver is pointed in a safe direction (See Rule 2,
Page 35).
2. Make certain both hands are dry and not impeded in any way – gloves,
bandages, cold, etc.
3. Grasp the revolver (if right handed) so that the thumb and forefinger of
your left hand are firmly holding the frame, forward of the trigger guard.
Thus, your left hand is in full control of the revolver (See Figure 4A, Page
15).
4. Place your right thumb firmly on the hammer spur and, with your thumb
securely in control of the hammer, squeeze the trigger only enough to
permit the hammer to ‘break free’ of the trigger. At that instant,
IMMEDIATELY RELEASE THE TRIGGER and then slowly permit the
hammer, STILL SECURE UNDER YOUR THUMB, to move fully forward to
its resting position against the frame. NOTE: It is imperative that finger
pressure be removed from the trigger just as soon as it is free of the
hammer. Then, properly, the trigger and hammer will move towards their
fully forward rest positions together (See Figure 4B, Page 15).
WARNINGFIRING
When firing the Redhawk revolver, be
sure all persons are a safe distance to the
rear of the shooter. When fired, all
revolvers discharge hot gas and particles
of lead, powder grains, or lubricant
through the clearance gap between the
cylinder and the rear of the barrel at high
speed. This can injure a person who is
standing too close to the revolver.
When firing the Redhawk revolver (or
any revolver), always be certain that
nothing – including your hands – is in
the path of the hot gas and particles
which are discharged from the front and
sides of the cylinder.
When shooting, adequate eye protection
is essential. Shooters and bystanders
must wear shooting glasses. Hearing
protection must also be worn. Exposure
to shooting noise can damage hearing.
HOT GASES EXIT
BARREL/CYLINDER GAP