Manual

4. Remove fingers from ejection port. Grasp slide tightly. Now press down on
slide stop and allow slide to move slowly
forward until the vertical disassembly
line on the frame is aligned with the vertical disassembly line on the slide (See
Figure 4, below). Press in on right-hand end of slide stop and pull slide stop out
of frame to the left until it is withdrawn completely out of the frame. (See Figure
5, below).
5. Push slide forward and remove entire slide assembly to the front.
6. Note: Camblock is under strong spring tension. With slide held upside down,
lift rear end of camblock/recoil spring assembly to disengage it from its seat
against the barrel lug. Withdraw the camblock/recoil spring assembly to the rear
of the slide.
7. Pull barrel upward out of slide slightly and withdraw to the rear.
8. This completes normal fieldstripping for routine cleaning and lubrication
purposes. Further disassembly of slide or frame components is not
recommended and should only be undertaken by the factory.
17
DEPRESS
EJECTOR
REMOVE
MAGAZINE
2
1
3
ALIGN
INDEX MARKS
PULL OUT
SLIDE STOP
4
DISASSEMBLY
NOTCH
FIGURE 3
Press slide stop up. Depress ejector.
FIGURE 4
Index marks aligned.
FIGURE 5
Slide stop in disassembly position.