Manual

SHIPPING FIREARMS FOR REPAIR:
RUGER
®
P95 pistols returned to the factory for services or repair should be
sent to: Sturm, Ruger & Company, Inc., Product Service Department, 200 Ruger
Road, Prescott, AZ 86301-6181. Telephone [phone].
Guns should be sent prepaid. W
e will not accept collect shipments.
The Federal Gun Control Act, as well as the laws of most States and localities, do
not prohibit an individual (who is not otherwise barred from purchasing or pos-
sessing a firearm) from shipping a firearm directly to the manufacturer for
repair. However, before you ship your pistol to us, be certain that your State or
locality does not have a law or regulation which will prohibit you from receiving
the pistol from us after it has been repaired. If such receiving is prohibited, then
please have a Federally Licensed Firearms Dealer ship the gun to us. If your pis-
tol is sent to us by a dealer, it will be returned to him after being repaired. If a
handgun (pistol or revolver) is shipped by an individual who does not hold a
Federal Firearms License, it must be shipped via U.P.S. (Next Day Air) Persons
who do not hold a Federal Firearms License are prohibited by Federal law from
shipping a handgun by Mail. Handguns mailed in violation of the law are
impounded by the Post Office.
Please do not include holster, custom grip panels, or accessories with a firearm
being shipped to the factory for service. DO NOT SEND GUN BOXES OR LIT-
ERATURE THAT YOU CONSIDER TO BE COLLECTOR’S ITEMS – THESE
ARE INVARIABLY DAMAGED OR DESTROYED IN SHIPMENT. Always insure
your shipment.
24
WARNING—BEFORE SHIPPING ANY FIREARM,
BE ABSOLUTELY CERTAIN THAT IT AND ITS
MAGAZINE ARE UNLOADED. DO NOT SHIP
CARTRIDGES WITH A FIREARM.
!
SERVICE AND PARTS POLICY
If you have any questions with regard to the performance of your RUGER
®
P95 pistol, please write or call (520-778-6555) our Product Service Department
in Prescott, Arizona, fully describing all circumstances and conditions involved.
If you should return your pistol to the factory for repair, or order parts for it,
please comply with the following suggestions for prompt service:
SIGHT ADJUSTMENT
The RUGER
®
P95 Pistols are equipped with a rear sight which is adjustable
for windage only. After the rear-sight lock screw has been loosened (for those
pistols equipped with a rear sight lock screw), the rear sight can be drifted later-
ally in its dovetail on the top of the slide by tapping it with a wooden- or plastic-
headed hammer or similar implement. Move the rear sight in the direction you
want the shot to move on the target. After the rear sight is adjusted, tighten the
rear-sight lock screw. The front sight is fixed. Both front and rear sights are pro-
vided with white-dot inserts for rapid target acquisition and easy alignment of
the sights to obtain a correct sight picture.