Manual

SAFETY "ON"
1
REMOVE
MAGAZINE
2
PULL SLIDE
TO REAR
3
DEPRESS
EJECTOR
4
of a pencil) through top of slide and push ejector downward and forward (see
Figure 7, below) until it locks in its lower position. This will permit forward
movement of slide. Further disassembly is impossible unless this is done.
23
FIGURE 7
Press slide stop up. Depress ejector.
FIGURE 8
Index marks aligned.
FIGURE 9
Slide stop in disassembly position.
PULL OUT
SLIDE STOP
6
4. Remove fingers from ejection port. Grasp slide tightly. Now press down on
slide stop and allow slide to move slowly
forward until the vertical
disassembly line on the frame is aligned with the vertical disassembly line on
the slide. (See Figure 8, above.) Press in on right-hand end of slide stop and
pull slide stop out of frame to the left until it is withdrawn completely out of
the frame. (See Figure 9, above.)
5. Push slide forward and remove entire slide assembly to the front.
6. With slide held upside down, lift rear end of camblock/recoil spring assembly
to disengage it from its seat against the barrel lug. Withdraw the
camblock/recoil spring assembly to the rear of the slide.
ALIGN
INDEX MARKS
5