Manual

32
SIGHT ADJUSTMENT
Shooting to determine the setting of the elevation slide (aperture) should be
done from a bench rest and over a measured distance.
The rear sight is adjustable for both windage and elevation. Lateral (windage)
adjustment is made by loosening the Rear Sight Windage Lock Screw (with the
hex-head wrench provided with the rifle) until the sight base requires finger
pressure to be moved. (See illustration below). Move the sight in the direction
you wish to move the point of impact. Before moving the sight, pencil mark an
index line on the sight base and on the receiver so that the amount of sight
movement can be detected. After desired positioning of the sight base has been
achieved, tighten the lock screw firmly.
1
1
2
2
WINDAGE ADJUSTMENT: To move the bullet impact point to the left, move
the rear sight base to the left. To move the bullet impact point to the right
,
move the rear sight base to the right. Be sure to retighten lock screw after
adjustment.
To Move Impact To Right
Move Sight Right
To Move Impact To Left,
Move Sight Left