Manual

7
Correct Installation of Lock For
Ruger
®
LCR
TM
Revolvers Only
Use the Correct Lock: While the basic locking device is substantially
similar for all Ruger
®
firearms, due to the different shapes of the many
Ruger
®
firearms, some firearms utilize different locking devices. The lock
with the 2 1/2” shackle (with the vinyl coating) is for use with the
RUGER
®
LCR
TM
revolvers. It is very important to use the correct
locking device!
To Install the Factory-Supplied Locking Device:
1. Keep the muzzle pointed in a safe direction and your fingers outside the
trigger guard at all times!
2. Be sure the firearm is completely unloaded and contains no cartridges or
cartridge cases!
3. Completely swing out the cylinder.
4. Apply the lock to the cylinder as shown in Figure 1.
5. Close the lock by pressing the shackle into the body of the lock (the part
that receives the key) as tightly together as possible. The lock has
bumpers and the shackle is coated with a non-marring material that will
not harm the metal finish of your firearm; be careful not to dent the
frame of the revolver.
6. Once the lock is securely closed, remove the key and pull firmly on the
lock to test the connection and be sure it is locked. Do not leave or store
your firearm with the key in the lock! Store your locked unloaded
firearm and the key in secure, separate locations, away from
ammunition, children, or unauthorized adults.
Figure 1