Manual

DISASSEMBLY

Read instructions before disassembling a gun.

1. BE CERTAIN THE REVOLVER IS UNLOADED BEFORE DISASSEMBLY.

2. Using a properly fitting screwdriver

(or screwdriver end of supplied lock

key), remove the grip retaining screw

from bottom of grip. Slide the grip

down off fire control housing (see

Figure 6).

3. Further disassembly is not required for normal cleaning purposes. Any further

disassembly should only be undertaken by trained factory service personnel.

REASSEMBLY

AGAIN, BE CERTAIN REVOLVER IS UNLOADED!

Before starting reassembly, be certain that all components and the inside of the

frame are thoroughly clean. Read instructions before re-assembling the firearm.

1. Slip the grip over the grip post. Insert the grip screw into bottom of the grip

and tighten.

WARNING –DISASSEMBLY

Always unload a firearm before

cleaning, lubrication, disassembly

or assembly.

Never remove or install a loaded

cylinder – it can fire if dropped or

struck.

UNLOAD BEFORE CLEANING

Figure 6