Manual

INSTRUCTIONS FOR ACCESSING
INTERNAL LOCK THROUGH RIGHT GRIP PANEL
If you would like to access the internal lock on your NEW MODEL
BLACKHAWK
®
without removing the grips, you can drill a small hole
through the right grip panel as follows:
1. Remove the right grip panel by unscrewing the grip panel screw.
2. On the inside of the right grip panel is a drill point (see Figure 3, below). On
the inside
of the grip panel, drill a 1/8” hole starting at the drill point.
3. Turn the grip panel over and, using the 1/8” hole you just drilled as a guide
hole, enlarge the hole using a 3/16” bit, this time drilling from the outside of
the panel inward.
4. Reattach the right grip panel and tighten the grip panel screw. The 3/16” hole
will allow key access to the internal lock without removing the grip panel.
!"#$$%&'#()%*+
!"#$ $%&'#()%*+!"#$$%&'#()%*+
!"#$ $%&'#()%*+
+)*")#(,%&'#()%-'"%
+)*")#(,%&'#()%-'"%+)*")#(,%&'#()%-'"%
+)*")#(,%&'#()%-'"%
./0%1'$/
./0%1'$/./0%1'$/
./0%1'$/
Figure 3
8
DRILL POINT AS
STARTING POINT FOR
KEY HOLE
INSIDE OF RIGHT GRIP PANEL SHOWN
Be sure to store the internal lock key in a secure location, away from children
and careless adults. Do not store your firearm with the key in the internal lock
keyway. Never lock a loaded gun – always unload the gun before locking.