Manual

29
SIGHTS
(ON REVOLVERS SO EQUIPPED)
ADJUSTMENT – Each click of the sight adjustment screw (either windage or
elevation) will move the point of impact of the bullet approximately
3/4” at a
range of 25 yards. The height of the front sight has been set to take advantage of
the elevation adjustment in the rear sight, considering the various ranges at
which the gun is most likely to be used. Barrel length and load used affects
trajectory. Therefore the shooter should determine sight settings by firing trials.
RIGHT
LEFT
To raise point of impact: turn screw
counterclockwise.
To lower point of impact: turn screw
clockwise
.
To move the point of impact to the right:
turn screw counterclockwise.
To move the point of impact to the left:
turn screw clockwise
.
SUGGESTED SIGHT PICTURE
Top of front sight even with top of
rear sight blade.
Front sight centered in notch of rear
sight blade. Target bullseye centered
on top of front sight.
UP
DOWN
ELEVATION WINDAGE
INTERCHANGEABLE SIGHTS
(HUNTER MODEL ONLY)
The HUNTER model revolver is provided with an insert front sight. To change
the front sight, depress the spring loaded plunger in the front of the barrel rib
with a small punch and lift rear of sight blade.