Manual

Firing a revolver with oil, grease, or any
other material even partially obstructing the
bore may result in damage to the revolver
and serious injury to the shooter and those
nearby.
Do not spray or apply lubricants directly on
ammunition. If the powder charge of a
cartridge is affected by the lubricant, it may
not be ignited, but the energy from the
primer may be sufficient to push the bullet
into the bore where it may become lodged.
Firing a subsequent bullet onto the
obstructed bore may damage the revolver
and cause serious injury or death to the
shooter and those nearby. Use lubricants
properly. You are responsible for the proper
care and maintenance of your firearms.
IMPROPER LUBRICATION
DESTROYS GUNS
26
Some cartridges with lead bullets deposit metal fouling in the chamber throats,
in the forcing cone of the barrel, and in the bore. If ‘leading’ is noted in your
revolver, clean it out before it builds up and interferes with reliable functioning
and accuracy. A special ‘lead removing’ cleaning tool (for bore and chambers) is
available from gun stores.
The revolver’s internal mechanism can be lubricated without disassembly. A few
drops of light oil recommended as suitable for firearms, applied periodically
about the various frame openings, will work its way into the mechanism parts.
The exterior of the revolver should be cleaned with a solvent and then wiped with
an oily cloth.