Manual

Never clean, lubricate,

disassemble or work on a

revolver while it is loaded.

Never install or remove a loaded

cylinder. A loaded cylinder can

discharge if dropped or struck.

Read instructions before

disassembling gun.

UNLOAD BEFORE CLEANING

Do not eject unfired cartridges onto any surface where the cartridge primer

might strike a solid object and discharge the cartridge.

CORRECT UNLOADING SEQUENCE

WARNING –DISASSEMBLY

REPEAT

FOR ALL

CHAMBERS

The user of a RUGER

NEW MODEL SINGLE ACTION revolver should

carefully read all disassembly directions and study all the illustrations and the

Parts List in this manual before attempting to take the gun apart. Know the

names and location of the parts before removing any of them. Although the

RUGER

NEW MODEL SINGLE ACTION revolver mechanism is

composed of only a few parts, it is essential that the disassembly and reassembly

operations be carried out with knowledge and care.

Only a few tools are required: A screwdriver or two to remove the grip panel and

grip frame screws, and a drift punch to remove the hammer and trigger pivots

(pins). A small plastic-faced hammer can be useful in drifting the trigger pivot

out and in.

REPEAT

FOR ALL

CHAMBERS