Manual

23
REASSEMBLY
1. Reassembling the bolt to the lever:
Open the lever. Insert the lever locking
link (L00900) on the top of the lever
housing into the slot in the bottom of
the bolt. Align the hole in the link with
the hole in the side of the bolt. Insert
the bolt link pin (L04900) into the hole
in the side of the bolt and push it
through the hole in the link until the
pin is flush with the sides of the bolt.
NOTE: Keep assembly level. Until the lever housing and receiver are
reassembled, tipping the housing sideways may allow the bolt link pin to fall
out of the bolt.
2. Reassembling the lever housing:
With the lever open, assemble the bolt
and lever housing to the receiver. The
back of the bolt should be against the
back of the lever housing as the bolt is
inserted into the receiver. Push the front
of the bolt upward as you slowly push the
lever housing into the receiver until the
front of the bolt is visible in the ejection
port.
3. Reassembling the receiver:
The lever housing can now be pushed
upward fully into place and the two
receiver pins can be pushed into their
respective holes, locking the receiver and
lever housing together.
4. Reassembling the remainder of the rifle:
Assemble the barrel - receiver to the stock
by following ( in reverse order) steps 1
through 5 under the “Dissasembly”
instructions.
5. Check functioning of assembled rifle. Be
sure it is unloaded!
Only now should the lever be fully closed.
Close the lever and open it a few times.
The bolt should lock, unlock, and retract
smoothly, and the safety should operate
normally.
GUNS SHOULD NOT BE STORED LOADED OR COCKED!
FRONT OF BOLT VISIBLE
4
3
2
1