Manual

22
4. Position the safety so an equal
amount of the button is exposed on
each side. If the safety is not in the
middle when the barrel-receiver
assembly is lifted out of the stock,
the stock will be damaged. Make
sure the lever is open.
5. Swing the barrel-receiver assembly
upward away from the forearm of
the stock. Be careful the two
receiver cross pins (B-5 & B-46) and
bolt stop pin (L00601) do not fall
out.
6. To remove the lever housing, again
make sure the lever is fully open.
Drift out the two larger diameter
receiver pins with a small diameter
screw driver or punch. Do not drive
out any of the smaller pins. Do not
disassemble the components of the
lever housing assembly. The bolt is
removed together with the lever
housing.
7. The bolt is separated from the lever
by pushing out the bolt link pin
(L04900).
This is the extent of disassembly required for routine inspection, cleaning and
lubrication. Further disassembly is not
recommended.
EQUAL AMOUNT OF SAFETY VISIBLE ON EACH SIDE