Manual

16
6. Cartridges can be removed from the magazine by simply pushing them lightly
downward and forward with the thumb, forefinger, or the rubber eraser end of
a pencil against the rim of the top cartridge. Do not use a loaded cartridge as a
‘tool’ to strip cartridges from the magazine.
7. If desired, the bolt can be left in the open position, being held there by the bolt
lock. If it is desired to close the bolt, again look to be certain the chamber is
empty. Put the safety “on”, retract the bolt to its rearmost position, release the
bolt lock and let the bolt snap forward. Keep your fingers out of the receiver!
8. With the muzzle pointed in a safe direction, push the safety to the “off” posi-
tion and pull the trigger to decock it. The rifle can be “dry fired” for practice as
long as it is empty and pointed in a safe direction.
9. Push empty (unloaded) magazine into the rifle until the catch locks it in place.
TO EXTRACT AND EJECT
A CHAMBERED CARTRIDGE
When the rifle is fired, the same gas pressure which drives the bullet forward also
acts through the cartridge case to push the bolt to the rear. That action causes
extraction and ejection of the fired cartridge case. But, when the bolt is operated
by hand, there can be a failure to extract the cartridge from the chamber, or a
failure to eject the cartridge clear of the rifle. These failures usually are the result
of the bolt not being pulled rearward vigorously, coupled with an accumulation
of bullet lubricant in the chamber. From the foregoing it is clear that the gun
user must:
1. Always visually check the chamber after opening the bolt to eject a chambered
cartridge. If the bolt is not vigorously retracted when being operated by hand,
the extracted cartridge can be ‘ejected’ into the magazine area, instead of out-
side the rifle.
2. Thor
oughly clean the chamber and the extractor as often as necessary to pre-
vent the accumulation of grease and dirt.
3. If an empty magazine is in the rifle when the bolt is being hand retracted to
extract a cartridge, the cartridge may drop on top of the magazine. Then when
the bolt goes forward, the cartridge will be chambered again! Always remove
the magazine before clearing the chamber, and visually ensure that no car-
tridges remain in the gun.
TO CLEAR A MALFUNCTION (“JAM”)
Any autoloading firearm may occasionally malfunction. If it does:
1. Be certain the muzzle is pointed in a safe direction and the safety is “on”.
2. If possible, first remove the magazine. It may be necessary to manually remove
a jammed cartridge which has only partially been stripped from the magazine.