User guide

61
Configuring the Access Point
Configuring Common Wireless Settings
Figure 30. The Configuration :: Wireless :: Advanced :: Common page
Setting Threshold Options
The following options allow you to fine-tune the “Protection Mode” behavior, set
previously on the Configuration > Wireless > Advanced > Common page. After
activating a Protection Mode, you can open each Wireless tab and customize the
threshold settings, which determine what is put in effect and when.
CAUTION: Do not customize these options unless you are an experienced network
administrator or are under the guidance of an IT/support professional.
To customize Protection Mode (Threshold) settings
1. Go to Configuration > Wireless. The Configuration :: Wireless :: Common page
appears.
NOTE: If you are using a ZoneFlex 7363/7762/7962 AP, go to Configuration > Radio
2.4G or Configuration > Radio 5G.
2. Click the tab for the Wireless # (WLAN) that you want to configure. The Configu-
ration :: Wireless :: Wireless [#] page appears.
3. Look for Threshold Settings, and then click Edit Settings. The Configuration ::
Wireless :: Advanced :: Wireless [#] page appears.