User guide

42
Installing the Access Point
Step 2: Verify Access Point Operation
Check the LEDs
Perform a spot-check using the LEDs to verify that the Access Point is operating
normally. Refer to the following sections for information on how to check the LEDs on
each ZoneFlex AP model.
ZoneFlex 2741/2942/7343/7942
If the Access Point is operating normally and your wireless client was able to associate
with it:
■ The WLAN LED is green.
■ If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED is
off. This indicates that the Access Point is operating in standalone mode. If there
is a ZoneDirector device on the network, the DIR LED is green.
ZoneFlex 7363 and 7962
If the Access Point is operating normally and your wireless client was able to associate
with it:
■ The 2.4G or 5G LED is green.
■ If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED is
off. This indicates that the Access Point is operating in standalone mode. If there
is a ZoneDirector device on the network, the DIR LED is green.
ZoneFlex 7762
If the Access Point is operating normally and no wireless clients are associated with it:
■ The Power LED is green.
■ The Status LED shows slow blinking amber. This indicates that there are no
wireless clients connected to the Access Point’s WLAN service.