User guide

Installing the Access Point

Step 1: Preconfigure the Access Point

Configure Common Wireless Settings

1. On the left menu of the Web interface, click Configuration > Wireless. The

Common page appears.

NOTE: For dual band APs (ZoneFlex 7962/7762/7363), the two radios (2.4GHz and

5GHz) need to be configured separately on the Web interface. To configure the

common wireless settings, click Configuration > Radio 2.4G or Radio 5G. The rest

of the configuration procedures are the same as the other models.

2. Verify that the common wireless settings are configured as listed in Tab le 17.

3. If you made any changes to the Common tab, click Update Settings.

4. Continue to “Configure Wireless # Settings”

below.

Table 17. Common wireless configuration

Setting Recommended Value

Wireless Mode Auto-select

Channel SmartSelect

Country Code • If you purchased the Access Point in the United

States, this value is fixed to United States at the

factory and is not user configurable.

• If you purchased the Access Point outside the

United States, verify that the value is set to your

country or region. Selecting the correct country

code ensures that the Access Point uses only the

radio channels allowed in your country or region.

Note for dual band AP users: The two radios on dual

band APs are always configured with the same country

code setting. If you change the country code for Radio

1, for example, the same change will be applied

automatically to Radio 2.